Visit our community sponsor
Thanks:
0
Likes:
0
-
David aka Ducky2009
My fill cap was spitting fluid out of the vent hole. Try this to check it. Take a paper towel and place the paper towel over the fill cap, hold on with a rubber band. I lowered the fluid level a little to remedy the issue. Fluid is now about 2/3 full.
Also: I added a O-Ring to the relief groove, where the vent hole goes through the cap. Not big enough to block the hole but cover most of it.
Last edited by Ducky2009; 04-22-2019 at 03:08 PM.
MK4 Build #9035 Delivered 2/17/17, First Start & Go-Kart 6/2/17, Licensed 9/1/17
Paint - Lightning Blue Metallic, No Hood Scoop, No Stripes
Gen 2 Coyote Engine & TKO-600. Solid Axle, 8.8-3.55, Power Steering, Power Brakes, Dual Roll Bars
Heater and Glove Box, Drop Trunk, Wipers, Radio, FFR Vintage Gauges, Custom Dash
Build Thread:
http://thefactoryfiveforum.com/showt...MK4-Build-9035
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor