Visit our community sponsor
Thanks:
0
Likes:
0
-
Autometer gauges-coyote motor-oil temp hook up
Hi Guys,
I'm running autometer gauges(amps, fuel, oil temp, oil pressure and water temp) and a 2017 coyote motor.
I have found where I hook up the oil pressure and water temp.
the coyote manual says nothing about where to hook up the oil temp.
Any input is appreciated
Thank you
Martin
-
Senior Member
What oil pan do you have?
-
aluminum low profile moroso
I think I just figured it out. use the same sending unit as the one for the water temp
M
-
Not a waxer
Originally Posted by
magicmarto
aluminum low profile moroso
I think I just figured it out. use the same sending unit as the one for the water temp
M
No, that would just give you two gauges reading the water temperature. Does your pan have an unused bung? If so that's where you would put the sender for oil temp. If you are using a remote filter the adapter will often have a port that will accept a sender, or if not it could be drilled and tapped for one.
Jeff
-
Senior Member
Originally Posted by
magicmarto
aluminum low profile moroso
I think I just figured it out. use the same sending unit as the one for the water temp
M
MOROSO pans have multiple bungs use one of them for the oil temperature sender.
You many need an adapter to match the pans threads to the senders threads. Got mine at Home Depot. I just used the bung closest to the senders wire lead plug.
Last edited by BEAR-AvHistory; 04-27-2019 at 04:28 PM.
-
yup
Same pan as mine
Will do
Thanks guys
Martin
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor