Anyone have any info on the correct Lokar shifter for a 4L70E mated to aLS3 in a 33 Hot Rod? I’ve read they are hard to fit?
Visit our community sponsor
Anyone have any info on the correct Lokar shifter for a 4L70E mated to aLS3 in a 33 Hot Rod? I’ve read they are hard to fit?
Lokar IMG_1317.JPGIMG_0021.JPG
33 Hot Rod (Gen 1) Stage 1 delivered on 4/27/2017, Stage 2 delivered on 9/21/2018
LS3 495hp/480 lb. ft., 4L70E, Electric PS, Classic Auto Air, Lokar electronic sport shifter, 13 inch Wilwood front and 11.68 Cobra rear brakes, Ford 8.8 w 3.73 w 4 link, Billet Specialty Legend Series MAG wheels and Mickey Thompson
Sportsman S/R 26x8x18 front and 29x18x20 rear tires.
I used the same shifter too. If you are going to build a console above the tranny cover and mount your shifter like I did consider ordering it with the 6" shift rod. The standard rod is only 4", however that is measured from the bottom of the nut at the base to the top of the mushroom ball.
See post 148 for how I mounted the shifter.
https://thefactoryfiveforum.com/show...-s-Build/page4
4" and 6" shift rod, 1st two pics in post 260.
https://thefactoryfiveforum.com/show...-s-Build/page7
Last edited by JimLev; 05-17-2019 at 09:14 AM. Reason: Added link
'33 Hotrod, #1047 Gen 1, delivered on 2/27/18, go cart on 9/24/18.
LS3 w/Gearstar Level 3 4L65e Tranny, Yank converter, Lokar shifter, Electric PS, Vintage AC/Heat/Def, 8.8" 3.55
TorqThrust II Wheels w/Toyo Proxy T1 Sport Tires, F 235/45ZR17 R 295/35ZR18
Garage Built, Driveway Painted.