Well, today the body went on and it was fairly straight forward except that even though the body is fitted tight at the bottom of the trunk and the front is right on, the lasered holes I PAID EXTRA FOR do not all line up or not the right size. The taillight and turn sigs front and back had to be enlarged to allow the units to seat properly. One of the holes in the body to accept the bolt for the rear outriders didn't accept it. I had to grind it into an oval to allow it to fit. The passenger side roll bar was off as well - grind it out. The worst one is the headers 4 in 4. They are 2" out towards the front. I have to cut out 2" which puts it really close to the wheel opening.

Anyone else have these problems?