Visit our community sponsor
Thanks:
0
Likes:
2
-
No, i haven't been. I supposed I could but I'm using Nicopp as the template for the eventual stainless steel lines so making a template before making my template seemed a little redundant. My problem so far has not been figuring out where I want my bends, it's been being able to put that bend in the tube where I want it, so I'm not really sure that making a template out of wire first would help a whole lot.
MkIV Roadster build: Gen 2 Coyote, IRS, TKO600. Ordered 10/24/18. Delivered 1/29/19. Engine installed 8/8/21. First start 9/12/21. First go-kart 9/17/21. Off to paint 4/11/22. Back from paint 12/30/22.
Build thread here.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor