Visit our community sponsor
Thanks:
0
Likes:
0
-
Mounting Wiper Motor without the Car Body on the Chassis
Guys,
I made the firewall cutout for my heater/defroster according to the F5 instructions. I need to make/position the cutout holes for the wiper motor. Is there a way to locate the wiper motor mounting holes without having the car body on the chassis as required in the F5 instructions for the wiper install?
Thanks,
Damien
-
David aka Ducky2009
If your firewall is attached, you should be able to add the wiper motor. If you hold a straight edge at the top of the firewall, parallel to the floor, that should simulate the body position. Before attaching the wipers, make sure you can bend the drive tube.... without any sharp bends. Most people use tubing other than what was supplies. The FFR tubing is hardened and almost impossible (not sure if anyone successfully achieved) to flare it.
Wiper Motor Mount.jpg
Last edited by Ducky2009; 06-19-2019 at 04:58 PM.
MK4 Build #9035 Delivered 2/17/17, First Start & Go-Kart 6/2/17, Licensed 9/1/17
Paint - Lightning Blue Metallic, No Hood Scoop, No Stripes
Gen 2 Coyote Engine & TKO-600. Solid Axle, 8.8-3.55, Power Steering, Power Brakes, Dual Roll Bars
Heater and Glove Box, Drop Trunk, Wipers, Radio, FFR Vintage Gauges, Custom Dash
Build Thread:
http://thefactoryfiveforum.com/showt...MK4-Build-9035
-
Senior Member
As Ducky says, you can easily locate the wiper mount without the body in place. Mock up the location of your blower in the engine compartment, and then tuck the body up under the 3/4" tube. Even though there's not a lot of room, there are lots of places for the motor to go. Play around with it to find a place that will make the tubing easy. Also, consider riv-nuts into the firewall so that if you ever have to change the wiper motor, you don't need a helper to hold the back side of the wiper mount bolts.
John
IMG_4347 by jhsitton, on Flickr
MK IV Roadster #8631
Ford 302, Holley Terminator EFI, T5z, 3.55 Rear End, IRS, 17” Halibrand Replicas (9” front, 10.5” rear), Nitto 555 G2’s (275/40ZR17 front, 315/35ZR17 rear), Fast Freddie’s Power Steering, F5 Wilwood Brakes, FFMetal’s Firewall Forward, Forte’s Hydraulic Clutch & Throttle Linkage
https://www.ffcars.com/threads/phile.../#post-4776313
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor