Working on the cab and bed. I need some advice on the dash. The instructions discuss the cutout for the steering column, but nothing about the roll bar. My dash is hitting the roll bar when I try to put it in. Any hints on cutting that part?
Visit our community sponsor
Working on the cab and bed. I need some advice on the dash. The instructions discuss the cutout for the steering column, but nothing about the roll bar. My dash is hitting the roll bar when I try to put it in. Any hints on cutting that part?
I trimmed mine till I got a good fit. Check post 169 on my build thread.. Enjoy your build.
https://thefactoryfiveforum.com/show...d-Pickup/page5
New question.
Putting the bed on and have a space issue. When we put the metal floor on and then the wood, they seem to go right to the side edge of the frame. I would think that is correct. However, when I then put the nylon spacer between the frame and the side pieces, I now have a space on each side of the bed of about 3/16. Without the nylon spacer, the sides bolt up pretty tight. What has everyone been doing with this?