Midwest Classic Insurance

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: Dashboard help

  1. #1
    Junior Member
    Join Date
    Apr 2019
    Posts
    12
    Post Thanks / Like

    Dashboard help

    Working on the cab and bed. I need some advice on the dash. The instructions discuss the cutout for the steering column, but nothing about the roll bar. My dash is hitting the roll bar when I try to put it in. Any hints on cutting that part?

  2. #2
    PLATNUM Supporting Member
    wallace18's Avatar
    Join Date
    Apr 2012
    Location
    Trenton, Florida
    Posts
    5,381
    Post Thanks / Like
    I trimmed mine till I got a good fit. Check post 169 on my build thread.. Enjoy your build.

    https://thefactoryfiveforum.com/show...d-Pickup/page5

  3. #3
    Junior Member
    Join Date
    Apr 2019
    Posts
    12
    Post Thanks / Like
    New question.
    Putting the bed on and have a space issue. When we put the metal floor on and then the wood, they seem to go right to the side edge of the frame. I would think that is correct. However, when I then put the nylon spacer between the frame and the side pieces, I now have a space on each side of the bed of about 3/16. Without the nylon spacer, the sides bolt up pretty tight. What has everyone been doing with this?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Replica Parts

Visit our community sponsor