can someone tell me if this is right for the rear brake hose? i tried putting it on 180º and it seemed to hit the halfshaf unless i bend it.
thanks!
IMG_9211.jpg
Visit our community sponsor
can someone tell me if this is right for the rear brake hose? i tried putting it on 180º and it seemed to hit the halfshaf unless i bend it.
thanks!
IMG_9211.jpg
I had mine installed by previous builder per the manual. The hose was touching something (the coil over if I remember correctly) . I looked at the C5 orientation and copied it, no more rubbing.
MK3.1 2004 Mach 1 donor. ABS, PS, TC.
GTM #304 LPE 525hp LS3
2000 C5 Lingenfelter LS1@489hp
1999 Corvette FRC/Z06 track car
could you possibly take a picture of from the back side? that way i can see how it should go. i have searched the internet for a picture of the back side but have had no luck. thanks!
Not sure if this will help, but here is my Wilwood setup. I think I have 18 inch lines, 45 deg fitting out of the calipers and straight fitting through the wheel well wall.
At full droop
MK3.1 2004 Mach 1 donor. ABS, PS, TC.
GTM #304 LPE 525hp LS3
2000 C5 Lingenfelter LS1@489hp
1999 Corvette FRC/Z06 track car
wow thanks!!!!!! that really helps a lot.
you rock!!