Visit our community sponsor
Thanks:
1
Likes:
0
-
Senior Member
Turn signal hole dimensions
Hi All.
I am finalizing the build of my body buck in preparation for the kit's arrival in a bit over a week. This will be a minimalist body buck design which will hang below the deck off the back of my house, and I am taking a page from this design with the two primary supports bolting onto the body at the front and rear turn signal mount points:
https://thefactoryfiveforum.com/show...l=1#post165404
Can somebody tell me the center-to-center measurements between the turn signal holes (distance between left and right for both front and rear)? I've been searching for a diagram showing this but no luck.
Thanks!
Jason
Last edited by Traveller; 08-15-2019 at 04:26 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor