-
Member
Anyone added an extra "pin" to Ron Francis EFI engine harness ECU connector?
Searched the forum on this and came up empty. Called Ron Francis and waiting on a response, but in the meantime I figured it would be wise to ask here.
I have a Vintage Air A/C system on my Mk 3.1 and a new Ron Francis EFI engine harness for an old school 302W. I want to add a wire split off from the A/C compressor to "pin 10" on the ECU to cause the computer to raise the idle RPM and whatever else the ECU does when A/C is on. I have the wiring mocked up but have no idea how to open up the connector to the ECU to add in the new wire.
Help...
Shack
-
Blue Oval Scribe
Ford EFI connectors (TFI, 60-pin ECU, etc. have red lock tabs/bars in them to retain the wire pins/terminals. You have to use a pick tool or jeweler's screwdriver to pry that lock tab out. Then you can access the terminals themselves to depin or relocate by carefully prying the release tab for the individual pins/terminals. In your case you'd just remove the red lock tab, insert your crimped terminal with wire lead until it clicks into the pin 10 location, then reinstall the red lock tab.
HTH!
Mark
Modified Mustangs & Fords Project Snake Charmer
FFR5310 Mk 3 Roadster
Tungsten Gray/Silver Stripes
-
Member
Thanks Mark! I'll try this on the old stock harness before I dig into the new one from Ron Francis.
-
Post Thanks / Like - 0 Thanks, 1 Likes
-
Senior Member
I am in the middle of installing thr North race cars system in my mk4 so this is information i can use to, so thank you guys!
Walt
FFR8237 Donor build 89 GT , MK 4 , T5 , 17 " hallibrands 9" front 10.5 rear ,4×4 headers stainless mufflers, dual chrome roll bars, coil overs all 4,A/C and heater , soft top, 3:55 gears.
-
Senior Member
On this extra pin, what wire, from where, and where would i get the part for this?
Thanks
Walt
FFR8237 Donor build 89 GT , MK 4 , T5 , 17 " hallibrands 9" front 10.5 rear ,4×4 headers stainless mufflers, dual chrome roll bars, coil overs all 4,A/C and heater , soft top, 3:55 gears.
-
On the subject of connectors used by Ford, I have found this to be useful:
https://www.motorcraft.com/content/d...-Book-2016.pdf
-
Senior Member
Thanks, i have the ron frances harness.
FFR8237 Donor build 89 GT , MK 4 , T5 , 17 " hallibrands 9" front 10.5 rear ,4×4 headers stainless mufflers, dual chrome roll bars, coil overs all 4,A/C and heater , soft top, 3:55 gears.