Midwest Classic Insurance

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Turn Signal Bezel Falling Off...

  1. #1
    Senior Member cv2065's Avatar
    Join Date
    Dec 2017
    Location
    Orlando, FL
    Posts
    1,836
    Post Thanks / Like

    Turn Signal Bezel Falling Off...

    I took my turn signals apart to have the bezels powder coated. I don't recommend doing that as putting them back together is a bit of a challenge with delicate pieces. Anyhow, the bezels are press fit on to the turn signal, and almost look like a one time deal, as once they are removed, the tension of the press fit is compromised. Rear tail lights are screw in, so not sure why FFR selected these. I put a little silicone on the areas that make contact, but wasn't enough to hold. Was thinking about maybe a set screw of some kind but didn't want to jack up my PC.

    Anyone run into this?
    MKIV Roadster - #9380 - Complete Kit - Delivered 7/17/18 - SOLD 5/2023
    Build Thread #1: https://thefactoryfiveforum.com/show...V-Build-Thread
    MKIV Roadster - #TBD - Complete Kit - Delivered 11/6/23 - In Progress
    Build Thread #2: https://thefactoryfiveforum.com/show...Build-Thread-2

  2. #2
    Senior Member
    Join Date
    Mar 2011
    Location
    Heart of Dixie, Alabama
    Posts
    1,848
    Post Thanks / Like
    While fitting mine, for the first time, I had to remove the chrome trim ring also. I was surprised, it is a friction, press on fit. I think more rtv might be the easiest answer.
    20th Anniversary Mk IV, A50XS Coyote, TKO 600, Trunk Drop Box, Trunk Battery Box, Cubby Hole, Seat Heaters, Radiator hanger and shroud.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Brown County Customs

Visit our community sponsor