While installing the new wheel studs for a rear hub on IRS I stripped the stud. What is the thread size.l? I will attempt to go to auto parts store and get a new one.
Visit our community sponsor
While installing the new wheel studs for a rear hub on IRS I stripped the stud. What is the thread size.l? I will attempt to go to auto parts store and get a new one.
The thread it 1/2x20, The knurl is what is important. I would take the stud with you. If memory serves I think it is a .615 knurl.
99/2000 NASA PSO Champion-2005 west coast FFR challenge series Champions
Sponsor Tony B's 2007 ST2 National Championship
2009 NASA TTC runner up-2010 NASA TTB runner up
Thanks Gordon, I will take out my dial calipers and check it out.
I had a similar issue and needed replacements. I ordered the following from Summit Racing:
Dorman Wheel Studs 610-290
Good luck!
My "Colorado Coop" build thread: https://thefactoryfiveforum.com/show...oop-quot-Build
Gadsden- thanks for the info I found what i needed and got it going