Today I mocked up the rear aluminum parts for the rear cockpit area. Then I started on the lower radiator cowl. I start by clamping it to the sides then mark where I have to trim. Do a little at a time. I could not get the bottom to line up as I needed so I cut the cowl down the center and took a small pie cut out of one side. I use 10-32 screws to mount the cowl to the grill. This allowed me to get a nice tight fit. I then temporally riveted a aluminum piece to the bottom to hold the halves in place. Then removed it and fiberglassed the inside today. Tomorrow I will fill the void and glass the bottom. Hope to get the hood all mounted tomorrow also.

3EFEB1AC-1ED7-4FD1-9E1C-F179D38449E9.jpeg7F9AA091-5C0C-4D3B-B7CC-EFD35522DB47.jpeg88C980E1-BCAA-431C-A898-680AB223393A.jpeg25C8980F-3439-4A8A-8728-1233A0D9694E.jpeg98D2F17A-4E5D-4593-9BA7-0B57D9A28FCB.jpeg3CA5B724-0AC6-4264-B95C-11F5E73B0172.jpegDEF20489-6357-42B9-B1DB-5835D8CBA1D2.jpeg179CEDE0-60A5-4A74-B88C-626975A3AF17.jpeg