FormaCars

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: Trick Flow top end (TFS- K514-360-SPC) with Boss 302 block (M-6010-BOSS302)

  1. #1
    Junior Member
    Join Date
    Dec 2012
    Posts
    6
    Post Thanks / Like

    Trick Flow top end (TFS- K514-360-SPC) with Boss 302 block (M-6010-BOSS302)

    Has anyone installed Trick Flow top end kit (TFS- K514-360-SPC) on a Boss 302 block (M-6010-BOSS302) ? Both are listed in the Challenge series rules. Boss 302 block requires 1/2 in. head bolts but the Trick Flow head from the kit uses a 7/16 in. bolt.

  2. #2
    Director of R&D, FFR Jim Schenck's Avatar
    Join Date
    Mar 2011
    Location
    Wareham
    Posts
    444
    Post Thanks / Like
    Dave,

    We did it for those same TFS heads on the 25 hour car using a 363 short-block from Ford. We just drilled out the heads for the 1/2 inch bolts. If you look at the description for heads on Trickflows site it has a little note at the bottom that says must be drilled out if using 1/2 inch head bolts, so that is not something they haven't accounted for material thickness wise. We used a drill press and went in small bit increments but if you aren't comfortable doing that it's something any local machine shop would do.
    Jim Schenck
    Factory Five Racing

  3. #3
    Junior Member
    Join Date
    Dec 2012
    Posts
    6
    Post Thanks / Like
    Thank you Jim !

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Replica Parts

Visit our community sponsor