I am installing my trans tunnel and bench seat. Of course one will not fit over the other. With the seat in position against the back of the cab (the 2x6 you see represents the back of the cab). The seat tunnel fits a good few inches above the tunnel. Before I cut and chop the tunnel to fit have you got any other suggestions? Also am I right in assuming the inside cab back touches the vertical part of the roll bar or when I get the cab on can I move the seat a bit further back? I am trying to position the seat for best comfort and most room. I have 1 1/2” under the back and the front sits on the floor. Do you have any other suggestions as to riser configuration for this truck.

IMG_1147.jpg