-
QA1 shock information needed
I need to determine the correct part number for QA1-DA single adjustment shocks. They are for the rear axle on a Mark 3/ 4 link. I know the topic has been covered many, many times. But rarely does the actual part number builders used show up. I must move forward with this your response is greatly appreciated.
-
Senior Member
There isn't a parts that is a direct bolt on. I sell QA1 kits, most double adjustable.
99/2000 NASA PSO Champion-2005 west coast FFR challenge series Champions
Sponsor Tony B's 2007 ST2 National Championship
2009 NASA TTC runner up-2010 NASA TTB runner up
-
Post Thanks / Like - 1 Thanks, 1 Likes
-
Seasoned Citizen
Don't waste your $$ on a single adjustable shock. Shocks control vertical tire speed in both directions and the damping needed is almost never the same in both directions. Get the double adjustable version -- they're good quality shocks for the money. And learn how to adjust them. I'm sure Gordon can help you select the right shocks and help you adjust them to fit your car's needs.
Dart Little M 406" SBC 800 HP N/A & 1,100 HP on nitrous, 2-spd Powerglide with trans brake, 6,000 RPM stall converter, narrowed Moser 88 3.90:1 spool with 35-spline gun-drilled axles & Torino bearings, custom parallel four-link, custom tube chassis & roll cage NHRA certified for 8.5-sec (only two FFR Hot Rods have this cert).
33 Hot Rod Super Pro Drag Racer Build:
33 HR NHRA Cert Roll Cage Build
-
Post Thanks / Like - 1 Thanks, 1 Likes
Thanks: 
Likes: 
Reply With Quote
