I got my offset dowels installed (Moroso). They don't come marked as to where the high spots are. I had to figure that out with my dial indicator. They are screw driver slotted to turn but I had to polish the ends down with crocus cloth so I could turn them in the block. They came with set screws. You have to drill and tap the block to use them. 8/32 so very small holes. So I have the bellhousing dialed in with .004 runout, .001 within max spec. Had to order a mechanical speedo block off plug (not included) as I am using the sensor for that. I had to buy some Grade 8 1/2"- 13 x 1 1/2" NC flange head bolts to mount the transmission, not quite there yet. Got those at Tractor Supply, shocked they had them. My go to hardware store didn't.
Anyone have problems with the trans mount fitting between the frame pieces it bolts to? I'm going to have to bend the ears of the mount or both to fit it in between. Till next post tata!