Any Gen 2 builders had this problem? The nose cone is 2 pieces as opposed to the 1 piece on the Gen1. Each side is like 4" too short to reach the grill varying from 4 to 2 inches at an angle. I tried to tilt the grill to match the angle but they are still too short. When I tilt the grill more upright to shorten the gap then the hood is too short with about 3 /4 inch gap on the cowel. When you put the pieces against the legs on the body the angle they're at doesn't put the front part at the same height of the grill. Any suggestions or should I contact FFR? I realize these cars aren't like Legos but give me enough material to work with.