Visit our community sponsor
Thanks:
0
Likes:
0
-
Windshield/rear window installation
The professional window installers in my area are not interested in installing hot-rod glass.
The manual says: “There are two ways to install the windshield, with weatherstrip around the edge of the windshield or without weatherstrip. We prefer without.”
I don’t like the look of the glued in glass. To me it looks unfinished and would prefer a rubber weatherstrip.
Has anyone used a weatherstrip they can recommend for the truck application.
Thanks
Cam
-
Senior Member
Here's what I will most likely do.
To "glue" the windshield and rear window, I'm using 3M Auto Glass Urethane # 08693. Lots of YouTube videos on this. Then, as an option, I may use this weather strip if it looks ok? Bought on Amazon, https://www.amazon.com/dp/B0892TZ4MH...roduct_details
Also bought on Amazon and viewed on YouTube, is this dense foam call glass damning. It will seal between glass and the cab lip. It will provide a finished look and prevent and urethane squeezing out. https://www.amazon.com/dp/B0892TZ4MH...roduct_details
Mark
-
Senior Member
Just to confirm, in either case they are glued in with auto glass urethane. The weatherstrip is just to cover the exposed edge of the glass. I did my Coupe with the weatherstrip material. Turned out OK. On my truck build I went without and I thought it looked OK too. I will warn you though we had to replace the windshield in my Coupe (a rock or whatever off the road...) and the weatherstrip made it much more difficult to remove the glass.
I had the same experience with both builds. None of the glass shops wanted anything to do with them. I was fortunate that through a club connection found a guy that worked in the industry (Dow) and was happy to help me. The truck glass is actually pretty easy to install compared to the Coupe. Relatively small, flat, and fit the openings quite well. If you get the right bead down, the glass presses right in.
Build 1: Mk3 Roadster #5125. Sold 11/08/2014.
Build 2: Mk4 Roadster #7750. Sold 04/10/2017.
Build Thread
Build 3: Mk4 Roadster 20th Anniversary #8674. Sold 09/07/2020.
Build Thread and
Video.
Build 4: Gen 3 Type 65 Coupe #59. Gen 3 Coyote. Legal 03/04/2020.
Build Thread and
Video
Build 5: 35 Hot Rod Truck #138. LS3 and 4L65E auto. Rcvd 01/05/2021. Legal 04/20/2023.
Build Thread. Sold 11/9/2023.
-
Senior Member
Cam, another note on my post above.... Use 3M Primer on the glass and paint.
Mark
-
Thank you for the information and grateful for all the help.
On past projects I had good results with Sikaflex P2G primerless to glass adhesive.
If I cant find a window installer as suggested by edwardb I'll glue it in.
Thanks to all
Cam
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor