Visit our community sponsor
Thanks:
0
Likes:
0
-
Coyote torque specs
I'm looking for torque specs for my coyote build.
1.Fly wheel do I need blue locktite?
2. Bell housing to engine?
3. Pressure plate to Fly wheel?
4. Tremec to rear bell housing?
Thanks much
-
Senior Member
Originally Posted by
DANW
I'm looking for torque specs for my coyote build.
1.Fly wheel do I need blue locktite?
2. Bell housing to engine? 35 ft lb
3. Pressure plate to Fly wheel? 33 ft lb plus 60 degrees
4. Tremec to rear bell housing? 45-65 ft lb
Thanks much
You should double check with FRPP re blue locktite however the torque specs they provided me are listed above
-
Thanks Jester, did they say what to torque the fly wheel down to? Also I am not sure what you mean by torque the pressure plate down to 33 ft lbs plus 60 degrees, I have read that before and not sure what the 60 degrees means.
Thanks.
-
Senior Member
Originally Posted by
DANW
Thanks Jester, did they say what to torque the fly wheel down to? Also I am not sure what you mean by torque the pressure plate down to 33 ft lbs plus 60 degrees, I have read that before and not sure what the 60 degrees means.
Thanks.
The plus 60 degrees means that you torque to the required setting then add an additional +60 degree turn to the bolt
Torque to for the flywheel to the crank is 80 ft lbs
-
Thanks and Happy New Year!!
-
Senior Member
Thx - Glad to help - good luck
Happy new year!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor