I'm happy to be doing something non-electrical for a change of pace.

Got some stuff in the mail:



That's a tube and rods ends to make a rear support brace, some aluminum bar for wiring harness support, a 0.1 inch thick 1'x4' piece of aluminum for an upper rear firewall to mount the ECU to, and a 0.1 inch thick piece of 1'x2' aluminum for the base of the fusebox.



This is a horrible picture of a 3'x3' piece of 0.040 aluminum to make new interior rear sides. I want to eliminate the sedan mount bays and extend to cover the area left open when installing a smaller tank.