Busy day worked on that inside corner, another little tab, a couple rivets, ready to upholster. The aluminum tab on the top will be used with a Dzus fastener to hold down the engine cover, no hood pin

Here is a shot of my finished center hood support. It holds the hood a full inch higher than the FFR piece of aluminum with the bulb molding on the top! More room for wipers!

I'm mounting my rear CF locking hood pins to the side panels not the rear clip. I had to space it down with aluminum spacers. I made a simple bolt up with a point on it to accurately center the holes to be drilled... Tomorrow perhaps?

The gold line shows where I'll shorten the trunk hinges... the rest gets in the way, easy to drill a new hole and relocate that second bolt

I got my aluminum IC bracket back from welding. You can see that the core will be fully exposed to the airstream. Some simple ducting and a sweet scoop and it will be all set. The fan is 10 inch diameter.

Some shots of my first mock up of the IC tubing. I need to swap out another 2 1/2 tube with a 45 degree bend. Perhaps 2 inch would fit better and reduce turbo lag. (at the expense of increased drag)

I made up a BPV manifold and used a 1.25 aluminum tube to dump into the intake tract's 2 3/4 inlet tube.

P1120113.JPG P1120120.JPG P1120119.JPG P1120118.JPG

P1120117.JPG P1120116.JPG P1120115.JPG P1120114.JPG

P1120111.JPG P1120121.JPG