Visit our community sponsor
Thanks:
20
Likes:
104
-
Moonlight Performance
Showing camber setup:
https://imgur.com/UrbX4Hz
Caster setup:
https://imgur.com/cUutzj6
Getting all tires level:
https://imgur.com/Y9tY0oH
What you are looking for:
First check inside, and zero it out here:
http://i.imgur.com/Cx7sam2.jpg
Next check outside and ensure it is still at zero. If so, you are parallel else adjust and recheck.
https://imgur.com/FL5SiCM
One more thing: your laser level device should stay in one spot. You can locate it where it will hit all the blocks or cone close. Use some angle iron as shown in the pic to hang the ruler a few inches off each block if you have to in order to hit the beam (though I didnt need to hang it iff on this side but I did on the other side of the car). If you use the angle on all four blocks whether you need it ir not, it keeps the measurements consistent. Man this is hard to explain, esp typing on a phone lol.
Last edited by Hindsight; 08-05-2016 at 02:39 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor