![BluePrint Engines](https://www.factoryfive.com/wp-content/uploads/2015/12/BluePrint_Engines_Factory_Five_banner_ad_revised.gif)
Visit our community sponsor
![Thanks](https://thefactoryfiveforum.com/dbtech/thanks/images/thanks.png)
Thanks:
0
![Likes](https://thefactoryfiveforum.com/dbtech/thanks/images/likes.png)
Likes:
0
-
Castle nuts tighten too low for cotter pin
Installing front suspension, ran into an issue. The castle nuts on both front spindles, upper and lower, tighten down further than the holes for the cotter pin (holes are above castle 'peaks'). I used the spacer on the lower and there was nothing to use on the upper. I haven't even torqued them yet, just snug with a wrench. Did I maybe do something wrong?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
![Martin's Dent and Collision Shop](https://www.factoryfive.com/wp-content/uploads/2019/02/martins-dent-shop.jpg)
Visit our community sponsor