Visit our community sponsor
Thanks:
0
Likes:
0
-
One more sheet metal question - lower trunk floor
Sorry for all the sheet metal questions lately. I think (hope) this is the last one. I'm looking at how the two trunk side pieces meet up with the rear edge of the lower trunk floor, and they're off a bit. The rear of the trunk floor sticks out past the side pieces by a good 1/4". I can't push the lower trunk floor any further forward. The side pieces are constrained by the upper shock tower mounts, so I can't slide those backward unless I enlarge the cutouts for the shock tower mounts. Is it normal for the sides to not meet up with the floor perfectly, or do I need to do something here, and if so, what?
Thanks,
John
MkIV Roadster build: Gen 2 Coyote, IRS, TKO600. Ordered 10/24/18. Delivered 1/29/19. Engine installed 8/8/21. First start 9/12/21. First go-kart 9/17/21. Off to paint 4/11/22. Back from paint 12/30/22.
Build thread here.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor