Just getting started on wiring, and as I look at each circuit, I'm reviewing all diagrams vs what I see on my wires and connectors, to get as much understanding as possible and avoid mistakes.

While the manual says to simply plug the steering column into the chassis harness plug, I did a comparison of the wire labels and descriptions between the harness manual and the IDIDIT instructions. The attached diagram shows what I found. Three of them seem to conflict (J, K & L). Might these have been pinned wrong?
column connector.jpg

I also put together this diagram based on what I found on IDIDIT's site. The diagram there had too many crossing wires to really visualize easily. This helped me to understand a little better.
IDIDIT Diagram.jpg