The problem as I see it is the "Z" shaped piece that may be need in a different application but not in this one. My solution will be to cut the leg of the "Z" piece off and then I can use the 3/4" bolt with enough threads for the nut to lock and not hit the spring.


Will post additional picks when completed.

The next issue that I ran into I have read about in other posts. The cables a just a tad short.


I have worked out a possible solution and will explain and post when it's complete.

My CV axles arrived a couple of days ago. They have been painted and installed!


Once I complete hooking up the e-brake the front and rear will be complete. Have to make a decision on panel finish so that I can start to install some of them for the last time. Then on to engine and transmission mockup. No first start until I get headers. No roller until I get tires.