Bump steer with new spindles

[FFRSpec72]

So with the new spindles on I finished up the frontend and set the alignment, I have the camber set @ -2.5 and caster @ 5.0 and toe-in at 1/16 and then went to set the bump steer and I can't seem to eliminate it, I get .1 inch for bump for every inch of suspension travel so at about 2.5 inchs of travel I get a 1/4 inch bump steer (wich seems quite a bit). To get this close I had to remove all the spacers. Anyone one else set/measured the bump steer?