![Forte's](https://www.factoryfive.com/wp-content/uploads/2015/04/fortes.gif)
Visit our community sponsor
![Thanks](https://thefactoryfiveforum.com/dbtech/thanks/images/thanks.png)
Thanks:
2
![Likes](https://thefactoryfiveforum.com/dbtech/thanks/images/likes.png)
Likes:
4
-
Senior Member
Sheared a Flywheel bolt - what's the right torque?? (Gen3 Coyote)
Following the manual installing the flywheel with bolts from Forte. Manual states 80 ftlbs. started hand tight around the 8 bolts, then walked them up in torque in a star pattern.
before I hit 80 ft lbs, i sheared a bolt off. Luckily it sheared at a point where I can remove easily, but now I'm back to square 1. will buy new bolts, but wondering if I either got a bad bolt or is the torque a lower value?
I'll call Mike Forte as well to get his thoughts, but curious if anyone else ran into this problem.
Thanks.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
![Breeze](https://thefactoryfiveforum.com/attachment.php?attachmentid=40534&d=1428868052)
Visit our community sponsor