Visit our community sponsor
Thanks:
0
Likes:
0
-
Coupe Build- Initial tie rod/rack width question
The coupe manual says to set up your initial tie width on the rack at 53-1/16" from center to center of the tie rod bolts. However, when I do this, it is extremely toed-in.
2024-01-13 09.17.55.jpg
Looking at the spindle arms (attached to the outer tie rod), it looks like mine have a greater offset than the one in the manual (below). The gap between the rotor and the tie rod appears bigger in the FF manual than in my install.
Image1.jpg
Any thoughts or help? Thanks. I realize I can just unthread the tie rods further, but I am curious whether I have a something wrong or an incorrect part.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor