Work on body fit again, will have to remove again for more trimming of a few panels. Side to side is great front and rear +/- 1/4, Height at front and rear fenders are with in 3/4 inch with a couple spots to trim that will hopefully shrink it to less than 1/2", not to crazy. Need to trim rear again I did 1/4 inch and need another 1/4 at least to get the door jambs lined up and body forward 1/4 inch.

But, the dash is pretty wonky how it lines up. on the Driver side, the carbon fiber will be pushing to the edge of the fiberglass at the dash curve (end of the square tube area) when I move the body forward 1/4 inch and may require some more trimming along the curve top, but the passenger side is over an inch difference and very obvious when looking along the dash.

Looks like the Passenger side will need to be built up to close that gap and at least make it look less obvious. Is this normal or a special child? I do not see any way to "fit" it any better, let me know if I am missing something.

Dash Issue.JPG
Driver side Dash Issue.JPG