Hi there -

I'm at wiring stage and have been staring at the mess of wires and reading posts here to come up with a plan. I read a post from Feb 2024 on moving the fuse box to the passenger side. Looks like GoDadGo and then ryanstory went this route. For you guys and others that have done this, I was looking for any additional advice on making the move.

It appears I'll need to:
1) make a bracket to hold the fuse panel under the dash (or use a dash filler plate and cut a hole in it).
2) move the horns to the passenger side in the engine bay
3) rewire the turn signals to swap left/right
4) extend the wires for the brake and clutch safety switches to the pedal box
5) other...?

I haven't looked ahead in the manual, but there is a space to the right of the firewall, and I'd like to run the front harness there (picture below). Any issues with this? I do not have a heater, wipers or glovebox.

I'm resisting the urge to diet the wiring harness so I can get on the road sooner than later...but we'll see.

Thanks, Joel

front_harness_route.jpg