Hello!

While not realizing that I was going to be using an hydraulic clutch initially, I corrected my path as I went along.
Now, while installing my clutch switch, I see in the illustration (below) a different set-up using the brackets (shown below), that I didn't even realize that I had.

I can find no instructions for the brackets, or any apparent reason for using them.

Can I now just put the switch on the existing framework, as indicated in the third photo? Is there a downside to this?

What am I missing here?

Chris
Screenshot 2024-12-01 at 7.47.53 PM.pngIMG_8297.jpgIMG_8300.jpg