They are WAY off. The trunk and hood were pretty good to go. I'll need to do some sanding and trimming, but I was able to make them both work without any thing yet. The doors needed my belt sander immediately. When I finally got the drivers side the lower forward corner is sunk about 1/8" below the body where everywhere else it's flush. Now the passenger side was giving me fits up by the dash. It's as if that door has too much curve at the top of the door.

I ordered some fiberglass chopped strand mat and a roller, I've already got a bunch of epoxy from my dashboard project. I'd rather bulk it up with that than bondo.