DIY Vintage Period Correct Girling Brake Reservoirs

[ehansen007]

This is my second go at making these reservoirs and although there is information out there, a lot of the parts have changed or are unavailable. Here is my write up on this fun little project:

Parts

Cans- Basco- $21 for three cans shipped with tax. https://bascousa.com/metal-cans-and-...-in-delta.html

Girling Lids and Stickers x3 (no longer water transfer) $74 Shipped https://prdcrrct.com/product/girling...v=0b3b97fa6688.

Actually I just realized you can get better, cheaper stickers here. I didn't notice mine didn't have the white outline. Not sure which is actually correct but I like the white outline better. https://embertonimperial.com/en-us/p...VUMv8OVVQfw44R

Brass 5/16" Bulkhead fittings (or 1/4" if you prefer) x2 pack $22 https://www.amazon.com/dp/B0CNGPBJLK...sin_title&th=1

Clamps: made myself for $20 with hardware

Paint- VHT Epoxy paint- $14

Acrylic Clear $14

All in: $155



Prepping Cans

Drill it. The metal is thin so best to angle it around a bit to get rid of any flared slag within the hold. This will flatten the hold for a good seat



Insert Bulkhead fittings with washers. I used some fuel-safe RTV to seal it.


Tighten those suckers down clean the excess off with Acetone


Scuff em' with scotch brite pad to get em' roughed up like the one on the left.


Make up some brackets with some steel strap stock. Drill holes and test fit hardware