I spent a ton of time over the holidays getting all of my electrical/wiring sorted, and I'm quickly approaching 1st start. I wanted to ask to forum about my clutch setup - before I do 1st start I just want to check and make sure the clutch is set up properly. This is my first build so I'm not sure if there is anything special I need to do. My setup is a Gen2 Coyote + T56 transmission + Forte hydraulic clutch setup. Clutch line has been bled already.

I know this is a dumb question but I'm going to ask it anyway as I'm nervous about this --> is there a way to check that the clutch engagement is set up correctly? Currently the car is up on jack stands and starter motor is installed too (not sure if that impacts anything). What procedure/tests/inspections can I do to confirm if the setup is good? Any advice here would be appreciated!