Just wanted to bounce my plan off of everyone.

Goal is less than 350WHP and fastest possible spool was the ultimate goal so I will be running a VF48, IWG...

I considered running a EWG but for the horsepower goal, could not justify it. As a compromise, I will run a Turbosmart IWG75 wastegate actuator with a 3 port controller (not sure which brand still waiting on a deal)

Was planning on sending the turbo to six star for simple porting and but I think i'll take it a step further and get the full rebuild with billet compressor wheel. With the porting should be good for about a 400-900 rpm spool improvement over the stock unit and a good 20-30 hp across the board.

They have a ball bearing upgrade in the works, and so I am considering holding off until closer to my delivery date.

Complete setup will be pushed with a ceramic coated Perrin ELH and first gen Cobb (cast) catless uppipe.

IMHO this will be pretty much the best VF48 setup money can buy.