Visit our community sponsor
Looking good. Lots of nice parts and clean installation.
Is that an AJW Exhaust ? If so I noticed that it is not centered (vertically) in the center of the rear panel, I have the same issue, mine is slightly higher but not by much. I see you are trying to get more air in the rear, how do you have your front fenders setup, is there a large enough space to allow the surface air to flow down the sides into the side vents and new areas you cut out ?
Tony Nadalin
2018 SOVREN Big Bore Champion
2015 SCCA Oregon Region VP3 Champion
2012 ICSCC ITE Class Champion
FFR MkII Challenge Car, Spec Racer, Street Legal, SCCA, ICSCC and NASA Racing
818R Build in progress
Are you going to come and join me racing? NASA West Coast Championships are coming to Laguna Seca
Thanks- Chad
818R-SOLD!!!- Go Karted 7/20/14/ Officially raced NASA ST2- 2/28/15
2016 Elan NP01 Prototype Racecar Chassis #20
1969 Porsche 911ST Vintage Race Car
1972 Porsche 911T (#'s matching undergoing nut & bolt resto in my garage)
Chad, you have been my "Hero" since I started this madness in September. If it hadn't been for your build threads, your R & D, and your helpful nature I would have S---CANED this project. Your successes have kept me going-Thank You!! I would love to join you on the track if I ever get this "beast" sorted out.