Visit our community sponsor
Thanks:
0
Likes:
0
-
Axle Adapter Bracket Bolts
Hi,
I am struggling with the bolts for the Axle Adapter Brackets. I'm using coil-overs, and the bolt to attached the lower coil-over assembly, the bracket and the shims is a 4" Larson Tuff Torq bolt, which is impossibly tight to push through the Axle Adapter Bracket. I can probably hammer it through, but it seems wrong to do so, and I am reluctant to drill out the bolt holes. Am I doing something wrong?
Thanks,
Jonathan
[email protected]
Mississauga, Ontario, Canada
289 USRRC Build started January 2018
Driven on track in FFR by Bob Bondurant himself in 2005, Phoeniz, AZ
Build School May 2011 (Strongly recommended)
-
Answering my own question....I took a leap of faith and drilled out the bolt holes on the adapter bracket. What seemed like a big job took less than 5 seconds, so now I'm re-assembling my axle after worrying about nothing all week.
Cheers!
Jonathan
[email protected]
Mississauga, Ontario, Canada
289 USRRC Build started January 2018
Driven on track in FFR by Bob Bondurant himself in 2005, Phoeniz, AZ
Build School May 2011 (Strongly recommended)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor