Hey guys. Getting some Saturday morning bellhousing alignment action going and needed to get some advice. Once completed, my readings are as follows:
12 o'clock = 0
3 o'clock = +4
6 o'clock = +4
9 o'clock = 0
I ran this twice to ensure that I ended up at zero and could duplicate my readings without error, and was good to go. My 12 o'clock zero was actually 3 o'clock, but I don't think it matters where you start. I've tried to find some info around the TKO600 tolerances, but am finding some conflicting stuff so thought I'd ask you guys. Are these readings good to go as is or do I need some kind of offset dowels?
IMG_0286.jpg