-
-
Post Thanks / Like - 1 Thanks, 1 Likes
-
I started going through the back order list and doing inventory. The back order list is very short and didn't contain anything that will slow me down right now.
I started this afternoon by assembling the shocks. I did both front and rear. Nothing unusual or different here.
After they were packed away I replaced the wheel studs in the rear IRS hubs. I knocked out the old ones with a large hammer. Used a hydraulic press to install the new ones. Pretty straight forward.
Hope to really get going on it Monday morning.
-
Mike,
That roadster behind it is really dusty. Could you run a rag over it for me?
-
In those pics you can really see the added Radius they put into the doors. Then I see some small changes to the frame. Should be a very nice build. Good luck.
-
Senior Member
Nice Mike, and sweet shop too!
John
-
Member
Nice. I will be following your build. My gen 2 33 is scheduled to delivered this week to nor cal. I’m also using a sbc.
-
Member
When you get a chance can you take a photo of your upper rear shock mounts. I have chassis #1121. With IRS and I have four different mounting points. Not sure which ones to use. Thanks
-
Use the wide ones that are directly above the lower mount. FFR has been shipping the wrong bolts though. You will need to buy longer ones. Pretty sure they are 1/2-13x4.
Mike
-
Member
Thank you for the quick response, that’s what I thought. And yes, The bolts were wrong that’s what caused me to think about it. I guess I’ll have to Get some different spacers also.
Thanks