This would be a perfect product for you to make. I guess the only thing left to say is, please?
rear diffuser slats.jpg
That picture is from the 2015 catfish that is on bring a trailer right now.
Visit our community sponsor
This would be a perfect product for you to make. I guess the only thing left to say is, please?
rear diffuser slats.jpg
That picture is from the 2015 catfish that is on bring a trailer right now.
I’ve been planning some of these. Been debating how to finish them. I’m leaning towards skinning them in CF to match the diffuser.
Did you want these for the FFR diffuser? My FFR diffuser came with some of these.
Zero Decibel Motorsports
Check out my new website!
www.zerodecibelmotorsports.com
www.facebook.com/zero.decibel.motorsports
Yes. Evidently mine did not include the slats.
Along with measurements, as I didn't receive them either.
Here's a design that will fit all 4 parts on a 12" x 24" sheet ($12 from McMaster). 'Open to comments and suggestions!
DIFF-STRAKE2-A0.JPG
DIFF-STRAKE2-A0 (2).jpg
818S #332, EZ30R H6, California licensed 01/2019
I need to buy a brake for my shop. Expensive to get one with any size to it.
Here's what the above design looks like in cardboard (sorry it was windy!). re. bending, a few pieces of angle-iron will suffice for 0.040 thick (or O2thin...) Al material.Strake1-a.jpgStrake1-b.jpgStrake1-c.jpg
818S #332, EZ30R H6, California licensed 01/2019
That looks good DSR..
Mine are made with .040 aluminum and the radius mimics the diffuser's curve for a better continuity of the curves.
Last edited by biknman; 10-18-2019 at 08:54 AM.
FFR 818r Instagram biknman69
2020 Ram 2500HD, 19 Forester Touring DD, 96 GM coupe for SCCA SM
“There are only three sports: bullfighting, motor racing, and mountaineering; all the rest are merely games.”
• Ernest Hemingway