Visit our community sponsor
Thanks:
85
Likes:
149
-
Senior Member
I was planning on working on the breeze roll bars soon. I’ve read some concerns with having them tack-welded while on the car in terms of damaging electronics.
I have most of the wiring in place. The engine is grounded and the EFI is wired. The fuel pump and all senders are wired.
The battery is disconnected and none of the gauges nor switches are hooked up yet.
Is tack welding the roll bars on the car a legitimate concern in this state?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor