-
E brake on 11.65 rear brakes
Is anyone running an IRS with the stock 11.65 brakes?
Running into an issue with e brake cable setup. The cable doesn’t have enough room to mount as required without running into the lower mounting bolt for the caliper. And the bend you have to make creates a real bind on the cable..
Any thoughts?
-
I’ve got the IRS with the stock 11.65 brakes.
The cables travel down the center of the car and then does a 90º to the calipers.
I can snap a pic tomorrow if you want.
Last edited by JimLev; 01-17-2024 at 11:32 AM.
Reason: Fix typo
'33 Hotrod, #1047 Gen 1, delivered on 2/27/18, go cart on 9/24/18.
LS3 w/Gearstar Level 3 4L65e Tranny, Yank converter, Lokar shifter, Electric PS, Vintage AC/Heat/Def, 8.8" 3.55
TorqThrust II Wheels w/Toyo Proxy T1 Sport Tires, F 235/45ZR17 R 295/35ZR18
Garage Built, Driveway Painted.
-
Post Thanks / Like - 1 Thanks, 0 Likes
Guy G thanked for this post
-
![Quote](images/misc/quote_icon.png)
Originally Posted by
JimLev
I’ve got the IRS with the stock 11.65 brakes.
The cables travel down the cent of the car and then do a 90º to the calipers.
I can snap a pic tomorrow if you want.
Thanks Jim
Did you have an issue with that bottom bolt for caliper?
-
-
when using these brakes, I countersink that hole and buy the proper bolt on McMaster-Carr.
https://www.mcmaster.com/catalog/130/3474/91304A174
Mike
-
![Quote](images/misc/quote_icon.png)
Originally Posted by
Guy G
Thanks Jim
Did you have an issue with that bottom bolt for caliper?
No clearance problems on mine. Do you have a Gen 2, might be a bit different than my Gen 1.
D5A1E384-B744-404B-AED3-5D01010B69DC.jpg
'33 Hotrod, #1047 Gen 1, delivered on 2/27/18, go cart on 9/24/18.
LS3 w/Gearstar Level 3 4L65e Tranny, Yank converter, Lokar shifter, Electric PS, Vintage AC/Heat/Def, 8.8" 3.55
TorqThrust II Wheels w/Toyo Proxy T1 Sport Tires, F 235/45ZR17 R 295/35ZR18
Garage Built, Driveway Painted.
-
I did what Mike Everson recommended. I have bolts if you need them but you will need to have a bit to countersink the tapered head.
-
![Quote](images/misc/quote_icon.png)
Originally Posted by
MC Builders
I did what Mike Everson recommended. I have bolts if you need them but you will need to have a bit to countersink the tapered head.
If I can get the bolts from you, that would be great!
I can get what I need to countersink.
Did you run into the same issue? For a while I thought it was me!!