Clutch switch set up

[ChrisNicholls]

Hello!

While not realizing that I was going to be using an hydraulic clutch initially, I corrected my path as I went along.
Now, while installing my clutch switch, I see in the illustration (below) a different set-up using the brackets (shown below), that I didn't even realize that I had.

I can find no instructions for the brackets, or any apparent reason for using them.

Can I now just put the switch on the existing framework, as indicated in the third photo? Is there a downside to this?

What am I missing here?

Chris
Screenshot 2024-12-01 at 7.47.53 PM.pngIMG_8297.jpgIMG_8300.jpg

[MSumners]

Maybe this. Coyote instructions page 80. Not sure if it’s what you’re thinking.

[ChrisNicholls]

Yes, this is the confusing page.
There are no build instructions that include the metal plates visible in that illustration.
I have moved on with the manual assembly and I'm wondering if I can just continue by mounting the switch on the existing 90 degree plate?

I can't see a structural reason not to, unless I am missing something.

Chris

[burchfieldb]

Maybe this. Coyote instructions page 80. Not sure if it’s what you’re thinking.

Is this specific to the Coyote engine?

[MSumners]

Is this specific to the Coyote engine?

I believe it is.

The two little metal pieces mentioned were included with my kit. In which box I do not recall.