GTM caliper decals or engraving

[HardRocker]

I’ve got brembos all the way around and would like to have some GTM decals on them. Did anyone ever make these? I’ve seen some calipers that were engraved which may be an option too, how to get that done if anyone knows.

[crash]

If your Brembos are anodized you can have them laser etched. I have had this done on anodized aluminum a few times. The etching people can also put a mask over where the laser etching is to create a more bright finish. I had this done on some parts and really could not tell the difference unless I held the part at a certain angle to the light. Etcher also said this would seal the surface better. I don't know about that as all my parts went inside the car.

The laser etching came out very sharp and clean.

I don't know if this can be done on powder coated parts or not.

Here is an example on anodized.

[HardRocker]

Thanks Crash. I’ll check into this as my calipers are raw uncoated. Do you know of a GTM logo or graphic repository? I’d also like to put the GTM graphic or logo on top of my fab aluminum intake manifold.

[crash]

I am unsure what you are referring to about a "GTM logo"? If you mean just the GTM lettering I am not even sure there is a specific font that is "standard". As far as I know most people make up their GTM badging details themselves. I am sure Shane at Vraptor has something digitized.

[VRaptor SpeedWorks, LLC]

I do have the GTM logo (same "font" as the badge that comes with the kit) drawn up in CAD. Used it for our aluminum engine covers:

https://vraptorspeedworks.com/alumin...-engine-cover/