Quote Originally Posted by tebriel View Post
I'm a little late to the game here, but Dan did you think about rotating the compressor housing to point towards the IC and eliminate some bends on your piping?
coulda, shoulda, woulda, I took the easy way out!

Now I'm remounting the body, anyone else having non symmetrical hump issues? The right one is about 8 inches high, has tons of bar clearance, the left, 7 1/2 or so inches and not much clearance at all. Squaring the engine cover front to back is a challenge as well.

P1120422.JPG P1120424.JPG

If I look under the engine cover it just barely clears the tubes running from the roll bar back to the frame under the humps