MRG MotorSports 818S Build

[DMC7492]

Congrats on the start! Very satisfying with the harness diet! However I am bit jealous as I don't have my engine installed yet.

[Bob_n_Cincy]

Congrats on the start! Very satisfying with the harness diet! However I am bit jealous as I don't have my engine installed yet.

Thanks
I figure I made about 400-500 wire cuts and 200-250 splices.
No mistakes found yet.
As Hannibal from the A Team always said: "I LOVE IT WHEN A PLAN COMES TOGETHER"
Bob

[RM1SepEx]

Thanks
I figure I made about 400-500 wire cuts and 200-250 splices.
No mistakes found yet.
As Hannibal from the A Team always said: "I LOVE IT WHEN A PLAN COMES TOGETHER"
Bob

I've been debating many of those cuts vs covering it with wire loom and dropping them into the tunnel...

[Bob_n_Cincy]

I've been debating many of those cuts vs covering it with wire loom and dropping them into the tunnel...

Most of my cuts were in this panel.
ggt.jpg
Then I made all the wire that go to the front about 10 ft long.
Once I had all the components where I wanted them, I started cutting and splicing again.
Bob