Visit our community sponsor
Thanks:
0
Likes:
0
-
Senior Member
gas pedal panel?
hi there, i was just about to mount my gas pedal (06 dbw) and in the manual it talks about an odd piece of aluminum that it gets bolted to. does this piece exist anymore? i thought i saw something like it when doing my initial inventory, but tore my garage apart looking for it, but cant find anything. i also looked through the build threads, and havent seen a lot of pedal shots to get this info. is this piece critical? or is everyone just bolting it to the firewall/frame? or should i be looking into making my own since i cant find the one in the manual? thanks
-
Some folks just bolt to the firewall (I think Wayne recommends this).
C.Plavan has also dealt with it in his build thread. You can see his final result in his post #159. I think he had pre-pics of what he was struggling with earlier in his thread.
Best,
-j
-
Senior Member
I bent my bracket (06 donor)to make it fit to my preferred height.
Bob
gas pedal.jpg
You should also add a stop behind the pedal so you don't break it off.
250px-Pedal_Locations_in_2007_Subaru_Legacy.jpg
Last edited by Bob_n_Cincy; 02-12-2014 at 11:50 PM.
-
Senior Member
ok sounds good thanks for the info, i dont think i have a bracket like that. i guess ill just throw it in where it feels right. thanks for the help!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor